Sebring Enduro Power muffler
Since my stock muffler got some holes in it, I had to think about a replacement.
I was sure, that it couldn't be fixed with some beer cans ;-) , as to be seen here
(that's why my
bike is called "Faxe Biturbo"), or here,
the winter '96 seasonal design.
The new pipe should be German TÜV proof, so mufflers like Arrows or Supertrap were out of
question.
Viewing the appearance, I tended to purchase the Laser ProDuro. Settling for
the Sebring, was a matter of money: the Laser is for DEM 757.- (US$ 450.-), the Sebring for
DEM 567.- (US$ 335.-). I purchased it from Detlev Louis,
because I get discount from them.
Mounting the Sebring
Shipped with the muffler is a mounting device for mounting it to the stock mounting
points. Mounting it was very easy, it took me all in all half an hour. The most
difficult thing, I guessed, would be removing the old muffler, but even that was
easy. I used some rust remover spray and let it take it's effect over night. A
little yank, and it was done. The real most difficult thing was to remove the
stock carbon gasket from the manifold, it's not used anymore. The muffler fitted
perfectly to the manifold and the lower mounting point at the pillion's foot peg,
An aluminium clamp is used for fixing the muffler to the upper mounting point on
luggage carrier. Read the additional mounting instructions.
Performance
I imagine there's a bit more of performance at mid revs (roundabout 4,000), and
I imagine the engine is kinda "plugged" at upper revs (roundabout 6,500 +). But
maybe I'm just imagining, it's not measurable. Accelerating from 50 km/h up to
120 km/h in 5th gear gives the same amount of time as before. V/max I clocked
a little bit lower, but that could be due to environmental conditions like wind,
air pressure, temperature or something like that. I'll watch it. I guess there
would be a better performance when removing the little end tube (they say up to 4 hp), but until now
I didn't dare. I guess it would be too loud for Germany, and I'm not sure if it's
refixable.
The sound
The sound is not directly louder, but it's harder than with the stock pipe. It
sounds like an off road bike now. Hear it
Problems
Lately, I had a problem. The aluminium clamp was broken, and
I didn't notice it.
This gave the muffler the opportunity to work on destroying the manifold by wobbling
around the pillion's footrest fixing point. The other day, it succeeded, and the manifold
broke, of course when
being in the middle of nowhere ... Thus, every now and then have a deeper look
to the fixing points, it may serve you the manifold. See details.
Back to Deti's Transalp Page
Back to pipes' page